| Page: 6 |
A number of bins are set up for each waveform in the "W.F. # list", evenly dividing the normalized cycles. For each cycle in the range to be analysed, a "sweep" is triggered at the start of each bin in the cycle, and the sweep is added into its bin. The window and delay are set as they are for spike triggered averages.
| Key sequence | Parameter | Initial Value |
|---|---|---|
| <Esc>AWC | Analysis method | Waveform averaging based on cycle phase |
| <Esc>SF | Run file | ? |
| <Esc>SRS | Start of run | 0 msec |
| <Esc>SRE | End of run | 2.14748e_08 msec |
| <Esc>SRD | # of deleted sections | 0 |
| <Esc>SCW | Cycle W.F. # | ? |
| <Esc>Wn<CR>SCV | Cycle crossings | ? |
| <Esc>SCS | Base cycles on stop time | N |
| <Esc>SCT | Base cycles on spike trains | N |
| <Esc>SCID | Phase selection delay | 0 msec |
| <Esc>SCIW | Phase selection window | 0.1 msec |
| <Esc>SAWL | W.F. # list | All |
| <Esc>SAWD | W.F. avg delay | 0 msec |
| <Esc>SAWW | W.F. avg window | ? |
| <Esc>SAB | # bins- avg | ? |
| <Esc>SCP | Percent of cycle active | 0 |
| <Esc>SAS | Start bin- avg | 1 |
| <Esc>SAP | Preview averaged data | N |
| <Esc>SDD | Graph description | "" |
| <Esc>SDSA | Auto scale | Y |
| <Esc>SDSXS | X scale bars | Y |
| <Esc>SDSYS | Y scale bars | Y |
| <Esc>SDTI | Interpolation | Y |
| <Esc>SDTX | Extend interpolation | Y |
| <Esc>SDTO | Overlay bins | N |
| <Esc>SDTR | Display relative levels | N |
| <Esc>SDTS | Display std dev | N |
| <Esc>SDTT | Top title display | Y |
| <Esc>SDUL | Sample units | mV |
| <Esc>SDUT | Time units | msec |
SCRC WWW administrator:
www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.