Page: 315 |
Affects: most graphs, trace and waveform averaging, raw waveform display
If disabled, the program interpolates only between points that are shown on the graph, and completely ignores points that are clipped out because they are too high or too low. This may give certain graphs a very "broken" appearance. If both the "Interpolation" option (or "Plot Interp." for plotter output) and the "Extend interpolation" option are enabled, then the program will perform partial interpolation between clipped points; line segments are drawn toward these points, up to the top or bottom of the graph.
Key sequence | Parameter | Initial Value |
---|---|---|
<Esc>SDTX | Extend interpolation | Y |