Page: 210

Analysis Help
Parameter: Base cycles on spike trains


Full name: Base cycle selection on spike activity trains
Parameter type: Y or N
Initial value: N

Affects: all analyses that use step cycles

The waveform parameter file for the selected "Cycle W.F. #" can contain markings for the starts and ends of cycle activity (duty), for the starts and ends of spike trains, or for both. Normally, cycles are based on the duty of the waveform. By setting this parameter to Y, you cause the spike train markers to be used instead.

 

Key sequence  Parameter Initial Value
<Esc>SCT  Base cycles on spike trains  N

 


SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.