Page: 209

Analysis Help
Parameter: Base cycles on stop time


Full name: Base cycle selection on stop time
Parameter type: Y or N
Initial value: N

Affects: all analyses that use step cycles

The cycle markings associated with the selected "Cycle W.F. #" consist of times for the start and the end of cycle activity (duty) on the waveform. Normally, each cycle is seen as the time from the start of activity, to the next start of activity. By setting this parameter to Y, you cause the time from the end of activity, to the time of the next end of activity, to be taken as a cycle.

 

Key sequence  Parameter Initial Value
<Esc>SCS  Base cycles on stop time  N

 


SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2017 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.