| Page: 275 |
Affects: all trace and waveform averaging
If this option is enabled, when you perform the "Go" operation after selecting a trace or waveform averaging analysis, the program will display every sweep that is being added into a bin.
After each screen-full, you are asked if you want to see more. You can enter Y to see another screen-full, N to continue averaging without previewing, or ESCAPE to abort the averaging. After the last screen-full of raw sweeps, hitting any key will cause the screen to be cleared and the averages to be displayed.
If this option is enabled during a graph of "W.F. L.D.P. level vs cycle duration", the calculated minimum and maximum levels are displayed as markers on the waveform. You can use the cursor to move the markers to the levels you desire, to correct the L.D.P. calculation. When you exit the preview display, the complete graph is shown. If you repeat the "Go" operation when the graph does not need to be recalculated, the program will ask you if you want to recalculate it anyway, and if not, whether you want to review the calculated levels.
| Key sequence | Parameter | Initial Value |
|---|---|---|
| <Esc>SAP | Preview averaged data | N |
SCRC WWW administrator:
www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.