Page: 207

Analysis Help
Parameter: Cycle W.F. #


Full name: Waveform # for step cycle selection
Range: [ -1, 99 ]
Initial value: not set

Affects: all analyses that use step cycles

In any analysis where data are broken down into cycles ("something" vs step cycle), this parameter determines which waveform's cycle markings are used for this purpose.

Apart from setting this parameter, you will also have to mark up the cycles for the waveform you have selected. These cycle markings are a part of the waveform parameter file associated with a waveform.

If you set this parameter to -1, then it will treat the entire range to be analysed as a single cycle. You will likely want to disable the "Normalization" option when using this feature.

 

Key sequence  Parameter Initial Value
<Esc>SCW  Cycle W.F. #  ?

 


SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2017 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.