Page: 205

Analysis Help
Parameter: End of run

Home › Software › Analysis Help › Parameters › End of run


Full name: End point of analysis range
Units: sec or per
Range: [ 0, 2 gp ]
Initial value: 2 gp

Affects: all analyses

This parameter determines the point in the run where data will no longer be analysed. Any data after this end time will be ignored. If set to a time greater than the length of the run file being analysed, the analysis will stop at the end of the run file. Initially, it is set to 2 giga-periods (billions of sampling periods, at the run's sampling frequency). This value is large enough to cover any possible run length.

The Start of run and End of run can be set visually, using the graphics terminal's pointing device to indicate the times on a waveform where to start and end. If you set the end to a point after the end of the displayed waveform, it will be set to the maximum allowable value.

When the range is set to a portion of the run, the "Next" and "Prev." menu items will shift the range to the next or previous portion of the same length.

 

Key sequence  Parameter Initial Value
<Esc>SRE  End of run  2.14748e_08 msec

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.