Page: 317

Analysis Help
Parameter: Display relative levels


Full name: Display relative levels for averaged trace(s)
Parameter type: Y or N
Initial value: N

Affects: all trace and waveform averaging

Normally, the program displays averages in absolute voltage units, and all bins for a given trace or waveform are displayed at the same range of voltage levels.

If the bins contain fairly weak signals, but there are large voltage offsets between bins, this type of display may not be appropriate. By setting this option to Y, you can get the bins displayed relative to the minimum level in each bin. They will still all be shown at the same scale, but the baseline is adjusted for each.

 

Key sequence  Parameter Initial Value
<Esc>SDTR  Display relative levels  N

 


SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2017 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.