Page: 321

Analysis Help
Parameter: Sample units


Full name: Units for A/D sample display
Parameter type: units (A/D or V)
Initial value: mV

Affects: most analyses, ampl. parameter setting

Whenever amplitudes (or levels) are displayed, on graphs or during parameter setting, this option determines the units in which they are shown. It also determines the default units used for setting amplitude parameters. You can set it to uV, mV, V, KV, or A/D units.

When setting an amplitude parameter, you can follow the number by one of the above unit specifiers, to override the current value. Actually, the specifiers "V" or "A/D" can be preceded by any of "a", "f", "p", "n", "u", "m", "K", "M", "G" or "T", representing atto-, femto-, pico-, nano-, micro-, milli-, Kilo-, Mega-, Giga- or Tera-Volts or A/D units.

 

Key sequence  Parameter Initial Value
<Esc>SDUL  Sample units  mV

 


SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2017 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.