Page: 370

Analysis Help
Parameter: Second W.F. trains

Home › Software › Analysis Help › Parameters › Second W.F. trains


Full name: Use second W.F. for end of train measurements
Parameter type: Y or N
Initial value: N

Affects: W.F. activity burst or spike train duration vs cycle duration

When this option is enabled, the end of burst durations or train durations are taken from the spike trains recorded in the waveform parameters of a second waveform, selected by the "Second ampl. W.F. #". Either the start or end of the burst is used, depending on the "Burst duration type" selected. This option overrides the "Second W.F. bursts" option, so if both are selected, the trains are used instead of the cycle activity for the second waveform.

 

Key sequence  Parameter Initial Value
<Esc>SMBST  Second W.F. trains  N

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.