Page: 369

Analysis Help
Parameter: Second W.F. bursts

Home › Software › Analysis Help › Parameters › Second W.F. bursts


Full name: Use second W.F. for end of burst measurements
Parameter type: Y or N
Initial value: N

Affects: W.F. activity burst or spike train duration vs cycle duration

When this option is enabled, the end of burst durations or train durations are taken from the cycle activity recorded in the waveform parameters of a second waveform, selected by the "Second ampl. W.F. #". Either the start or end of the burst is used, depending on the "Burst duration type" selected. If the "Second W.F. trains" option is also selected, it overrides this one, so the trains are used instead of the cycle activity for the second waveform.

 

Key sequence  Parameter Initial Value
<Esc>SMBSC  Second W.F. bursts  N

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.