| Page: 324 |
Affects: Raw waveform display, W.F. displayed when setting parameters visually
This option specifies whether frame trigger time markers should be show when waveforms are displayed for visual parameter setting. If enabled, marker dots will appear above the waveform, indicating the trigger times of all frames in the range displayed.
For the "Raw waveform display", a trace (selected by the "Amplitude trace #") will be displayed if this option is enabled. The top quarter of the display, or whatever is specified by the "Trace display height" parameter, will be used to display sweeps from this trace. The sweeps are displayed vertically, and the first point of each sweep is lined up with the time (on the waveforms below) at which the frame containing the sweep was triggered. Deleted frames, and frames whose tag values are not in the "Tag list" are excluded. If the trace selected by the "Amplitude trace #" doesn't exist, the frame positions are indicated, but no sweeps are shown.
| Key sequence | Parameter | Initial Value |
|---|---|---|
| <Esc>SDWM | Mark frame positions on W.F. | N |
SCRC WWW administrator:
www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.