Page: 323

Analysis Help
Parameter: W.F. Interpolation

Home › Software › Analysis Help › Parameters › W.F. Interpolation


Full name: Interpolate points in W.F.s for parm. setting
Parameter type: Y or N
Initial value: Y

Affects: waveforms displayed when setting parameters visually

This option specifies whether linear interpolation should be performed on the waveforms displayed for visual parameter setting. If disabled, only the data points are shown. If enabled, the data points will be shown, and will be interconnected by line segments.

Note that large waveforms are displayed more quickly when interpolation is enabled, since the program can eliminate redundant points from the display.

Separate options, "Interpolation" and "Plot Interp.", control interpolation for final displays of analyses, and for plotter output.

 

Key sequence  Parameter Initial Value
<Esc>SDWI  W.F. Interpolation  Y

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.