Analysis Help
Waveform Parameter: Single-unit data set #

Home › Software › Analysis Help › Parameters › Single-unit data set #

Affects: all W.F. spike analyses, automatic generation of spike activity markers

This parameter selects the single-unit data set to be modified by the "Automatic" or "Manual" selections, or to be used in any W.F. spike analysis on the current waveform. The data sets are numbered starting at 1.

It can be set to a number greater by 1 than the number of single-unit data sets currently present in this waveform's parameters. Then, the "Automatic" selection will create a new single-unit data set, rather than modifying an existing set.

If this parameter is set to 0, the program will not use any of the single-unit data sets in the waveform parameter file, but will instead include in the analysis all spikes selected by the current "Spike threshold", "Spike hysteresis" and "Spike discriminator".

SCRC WWW administrator: www@scrc.umanitoba.ca