Page: 372

Analysis Help
Parameter: Notch filtering

Home › Software › Analysis Help › Parameters › Notch filtering


Full name: Perform notch filtering, rather than lowpass
Parameter type: Y or N
Initial value: N

Affects: Filter operation

Normally, the filter performs low-pass filtering. Enable this option to perform notch filtering instead. Note that the option for "Highpass filtering" will override this one, so it should be disabled if you want to enable notch filtering.

 

Key sequence  Parameter Initial Value
<Esc>MFN  Notch filtering  N

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.