Page: 338

Analysis Help
Parameter: Highpass filtering

Home › Software › Analysis Help › Parameters › Highpass filtering


Full name: Perform highpass filtering, rather than lowpass
Parameter type: Y or N
Initial value: N

Affects: Filter operation

Normally, the filter performs low-pass filtering, or notch filtering if the "Notch filtering" option is enabled. Enable this option to perform high-pass filtering. It will override the "Notch filtering" option if both are enabled, so you must disable "Highpass filtering" to perform notch filtering, or disable both to perform the default low-pass filtering.

 

Key sequence  Parameter Initial Value
<Esc>MFH  Highpass filtering  N

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.