Page: 235

Analysis Help
Parameter: W.F. amplitude window


Full name: Window for W.F. amplitude measurement
Units: sec or per
Range: [ 0, 2 gp ]
Initial value: 1 p

Affects: graphs where X-axis is W.F. amplitude, averaging based on W.F. level

The parameters "W.F. amplitude delay" and "W.F. amplitude window" indicate a range of points, relative to the time of some event in the Y-axis data, used to obtain a level reading on the waveform. The positive or negative delay is an offset from the time of the event, where the window for measurement is to begin. The window is the length of time the waveform is measured to obtain an average level reading.

 

Key sequence  Parameter Initial Value
<Esc>SLWW  W.F. amplitude window  0.1 msec

 


SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2017 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.