Page: 233

Analysis Help
Parameter: W.F. ampl. as % of max

Home › Software › Analysis Help › Parameters › W.F. ampl. as % of max


Full name: Show W.F. amplitudes as a percentage of the maximum
Parameter type: Y or N
Initial value: N

Affects: all W.F. amplitude graphs

For graphs of waveform amplitude, this parameter selects how the axis will be labeled. Normally, it is labelled in mV, V, A/D units, or some such measure of amplitude. If you set this option to Y, the axis will be labelled as percentages of the maximum waveform amplitude measured in the course of this analysis on this run of data, unless the maximum happens to be zero.

 

Key sequence  Parameter Initial Value
<Esc>SLWP  W.F. ampl. as % of max  N

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.