Page: 250

Analysis Help
Parameter: Spikes to skip


Full name: Number of spikes to skip at start of cycle
Range: [ 0, 32767 ]
Initial value: 0

Affects: graphs where X-axis is spike occ., averaging based on spike occ.

The "Spikes to skip" parameter can be set to indicate how many spikes to ignore at the beginning of each cycle. If it were set to, say, 5, then 10 bins would represent the sixth to the fifteenth actions potentials. If the "Reverse spike occurrences" option is then enabled, the 10 bins would represent the fifteen down to the sixth action potentials from the end of the cycle.

 

Key sequence  Parameter Initial Value
<Esc>SSWS  Spikes to skip  0

 


SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2017 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.