Page: 417

Analysis Help
Waveform Parameter: Spike baseline

Home › Software › Analysis Help › Parameters › Spike baseline


Full name: Baseline W.F. level where spikes start and end
Units: V or A/D
Range: [ -32767 A/D, 32767 A/D ]
Initial value: not set

Affects: automatic selection of single-unit spike data

This parameter is used only when automatically setting single-unit data, to further eliminate spikes not rejected by the basic threshold-hysteresis-discriminator spike detection algorithm.

It selects the baseline level at which the signal usually returns after a spike. The spike is considered to end once the signal returns to baseline. The time from onset to baseline crossing is taken to be the width of the spike.

 

Key sequence  Parameter Initial Value
<Esc>Wn<CR>SSUB  Spike baseline  0 mV

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.