Page: 221

Analysis Help
Parameter: Second trace ampl. as % of max

Home › Software › Analysis Help › Parameters › Second trace ampl. as % of max


Full name: Show Y axis trace amplitudes as a percentage of the maximum
Parameter type: Y or N
Initial value: N

Affects: Y-axis of Y-vs-X trace amplitude graphs

For graphs of trace amplitude vs trace amplitude, this parameter selects how the Y-axis will be labeled. Normally, it is labelled in mV, V, A/D units, or some such measure of amplitude. If you set this option to Y, the axis will be labelled as percentages of the maximum trace amplitude measured for the Y-axis in the course of this analysis on this run of data, unless the maximum happens to be zero.

 

Key sequence  Parameter Initial Value
<Esc>SLSTP  Second trace ampl. as % of max  N

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.