Page: 337

Analysis Help
Parameter: Sample rate divisor

Full name: Sampling rate divisor
Range: [ 1, 32767 ]
Initial value: 1

Affects: Filter operation

After low-pass filtering, you may not have to keep the waveform at its original resolution. To lower the resolution, set this parameter to some integer value which will divide the waveform's sampling rate. For example, if you set it to 10, nine tenths of the resulting points are discarded.


Key sequence  Parameter Initial Value
<Esc>MFD  Sample rate divisor  1


SCRC WWW administrator:
Copyright © 2017 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.