Section: User Commands (1)
Return to Main Contents
addwfs2run - add waveform data from other runs to a run file
runfile otherrun.wnn ...
copies waveform files from one run file to another, adding them as new
waveforms in the target
argument specifies the name of the run file to be modified, and the
arguments specify one or more waveform files from other runs, where the
is the 2 digit waveform number.
The specified waveform files will be copied as new waveforms that are
added to the runfile. You should ensure that the effective sampling
rate of the waveforms evenly divides the sampling rate of the runfile,
so that the data lines up correctly with existing waveforms.
will pick the closest integer sampling rate divisor and use this for
each added waveform. You should also use runfiles whose length match
reasonably well. If the waveforms you add have a different run length
than the specified runfile, the shorter waveforms will be padded with
zeros to the appropriate length.
The purpose of this is to allow combining related analysis data from
multiple sources, such as adding limb position and angle data from a
motion capture system to EMG/ENG data captured separately at the same time.
*.frm frame file containing run header
*.w?? waveform files
proa2run(1), asc2run(1), analysis(1), frmfile(5)
- SEE ALSO
This document was created by
using the manual pages.
Time: 20:21:24 GMT, November 21, 2017
Copyright © G. R. Detillieux,
Spinal Cord Research Centre,
The University of Manitoba.