Page: 242

Analysis Help
Parameter: Trace spike threshold

Home › Software › Analysis Help › Parameters › Trace spike threshold


Full name: Threshold for spikes on trace
Units: V or A/D
Range: [ -32767 A/D, 32767 A/D ]
Initial value: not set

Affects: graphs of trace spike count or latency vs step cycle

For each frame in a trace spike count or latency graph, the selected trace is searched for spikes. The spike measurement is controlled by the "Trace spike threshold", "Trace spike hysteresis", and "Trace spike discr.". Any spike that crosses the threshold, does not exceed the discriminator level, and falls below the hysteresis, is included in the graph.

 

Key sequence  Parameter Initial Value
<Esc>SSTS  Trace spike threshold  ?

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.