| Page: 2 |
A number of bins are set up for each trace in the "Trace # list", evenly dividing the normalized cycles. Each frame in the range to be analysed is added in to the appropriate bin, based on the point in the cycle where the frame was triggered. Deleted frames, and frames whose tag values are not in the "Tag list" are excluded.
| Key sequence | Parameter | Initial Value |
|---|---|---|
| <Esc>ATC | Analysis method | Trace averaging based on cycle phase |
| <Esc>SF | Run file | ? |
| <Esc>SRS | Start of run | 0 msec |
| <Esc>SRE | End of run | 2.14748e_08 msec |
| <Esc>SRD | # of deleted sections | 0 |
| <Esc>SCW | Cycle W.F. # | ? |
| <Esc>Wn<CR>SCV | Cycle crossings | ? |
| <Esc>SCS | Base cycles on stop time | N |
| <Esc>SCT | Base cycles on spike trains | N |
| <Esc>SCID | Phase selection delay | 0 msec |
| <Esc>SCIW | Phase selection window | 0.1 msec |
| <Esc>ST | Tag list | All |
| <Esc>SATT | Trace # list | All |
| <Esc>SAB | # bins- avg | ? |
| <Esc>SCP | Percent of cycle active | 0 |
| <Esc>SAS | Start bin- avg | 1 |
| <Esc>SAP | Preview averaged data | N |
| <Esc>SDD | Graph description | "" |
| <Esc>SDSA | Auto scale | Y |
| <Esc>SDSXS | X scale bars | Y |
| <Esc>SDSYS | Y scale bars | Y |
| <Esc>SDTI | Interpolation | Y |
| <Esc>SDTX | Extend interpolation | Y |
| <Esc>SDTO | Overlay bins | N |
| <Esc>SDTR | Display relative levels | N |
| <Esc>SDTS | Display std dev | N |
| <Esc>SDTT | Top title display | Y |
| <Esc>SDUL | Sample units | mV |
| <Esc>SDUT | Time units | msec |
SCRC WWW administrator:
www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.