Page: 214

Analysis Help
Parameter: Trace amplitude point


Full name: Offset to trace amplitude sample point
Units: sec or per
Range: [ 0, 2 gp ]
Initial value: not set

Affects: all trace amplitude graphs

Trace amplitude measurements are taken on each frame as the difference between the level at this sample point, and the level at a reference point.

This parameter can be set by specifying the time offset from the start of the sweep. It can also be set visually, using the pointing device to indicate the time on the displayed sweep for the sample point (and the reference point).

 

Key sequence  Parameter Initial Value
<Esc>SLTS  Trace amplitude point  ?

 


SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.