Page: 216

Analysis Help
Parameter: Trace ampl. point window


Full name: Search window for trace amplitude sample point
Units: sec or per
Range: [ -2 gp, 2 gp ]
Initial value: 1 p

Affects: all trace amplitude graphs

Normally, the trace amplitude sample is taken from a single point in each frame. By setting this parameter to a larger value, you can cause the program to search an area of the length you specify, from the given "Trace amplitude point", for a maximum or minimum level. This level will be used as the sample, from which the reference level is subtracted.

 

Key sequence  Parameter Initial Value
<Esc>SLTWS  Trace ampl. point window  0.1 msec

 


SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.