Page: 213

Analysis Help
Parameter: Trace ampl. as % of max

Home › Software › Analysis Help › Parameters › Trace ampl. as % of max


Full name: Show trace amplitudes as a percentage of the maximum
Parameter type: Y or N
Initial value: N

Affects: all trace amplitude graphs

For graphs of trace amplitude, this parameter selects how the axis will be labeled. Normally, it is labelled in mV, V, A/D units, or some such measure of amplitude. If you set this option to Y, the axis will be labelled as percentages of the maximum trace amplitude measured in the course of this analysis on this run of data, unless the maximum happens to be zero.

 

Key sequence  Parameter Initial Value
<Esc>SLTP  Trace ampl. as % of max  N

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.