Page: 405

Analysis Help
Waveform Parameter: Strict triggering

Home › Software › Analysis Help › Parameters › Strict triggering


Full name: Strict trigger mode for cycle selection
Parameter type: Y or N
Initial value: Y

Affects: automatic generation of cycle activity markers

This option determines what action the program takes after finding a threshold crossing, and jumping ahead in the waveform by the "Cycle crossing delay". If at this point, the signal is on the wrong side of the threshold (above after a negative crossing, or below after a positive crossing), the program will ignore the last crossing if this option is enabled.

If this option is disabled, the rules are relaxed, and all crossings are used.

 

Key sequence  Parameter Initial Value
<Esc>Wn<CR>SCT  Strict triggering  N

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.