Page: 222

Analysis Help
Parameter: Second trace ampl. point

Full name: Offset to second trace amplitude sample point
Units: sec or per
Range: [ 0, 2 gp ]
Initial value: not set

Affects: Y-axis of Y-vs-X trace amplitude graphs

Y-axis trace amplitude measurements are taken on each frame as the difference between the level at this sample point, and the level at a reference point for the Y-axis trace.

This parameter can be set by specifying the time offset from the start of the sweep. It can also be set visually, using the pointing device to indicate the time on the displayed sweep for the sample point (and the reference point).


Key sequence  Parameter Initial Value
<Esc>SLSTS  Second trace ampl. point  ?


SCRC WWW administrator:
Copyright © 2017 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.