Page: 238

Analysis Help
Parameter: Second min W.F. ampl.

Home › Software › Analysis Help › Parameters › Second min W.F. ampl.


Full name: Minimum level for Y-axis W.F. amplitude
Units: V or A/D
Range: [ -32768 A/D, 32767 A/D ]
Initial value: -32768 A/D

Affects: W.F. level vs W.F. level graphs

For graphs of W.F. level vs W.F. level, this parameter can be set to reject Y-axis levels that are too low. It can be set along with the "Second max W.F. ampl." parameter to limit the range of levels included in the graph.

This parameter can be set by specifying the level in mV or A/D units. It can also be set visually, using the pointing device to indicate, on the displayed waveform, the minimum level (and the maximum).

 

Key sequence  Parameter Initial Value
<Esc>SLSWRL  Second min W.F. ampl.  -80000 mV

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.