Page: 240

Analysis Help
Parameter: Second W.F. ampl. as % of max

Home › Software › Analysis Help › Parameters › Second W.F. ampl. as % of max


Full name: Show Y-axis W.F. amplitudes as a percentage of the maximum
Parameter type: Y or N
Initial value: N

Affects: W.F. level vs W.F. level graphs

For graphs of W.F. level vs W.F. level, this parameter selects how the Y-axis will be labeled. Normally, it is labelled in mV, V, A/D units, or some such measure of amplitude. If you set this option to Y, the axis will be labelled as percentages of the maximum waveform amplitude measured for the Y-axis in the course of this analysis on this run of data, unless the maximum happens to be zero.

 

Key sequence  Parameter Initial Value
<Esc>SLSWP  Second W.F. ampl. as % of max  N

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.