Page: 362

Analysis Help
Parameter: Last trace only

Home › Software › Analysis Help › Parameters › Last trace only


Full name: Show only last trace in range horizontally above W.F. display
Parameter type: Y or N
Initial value: N

Affects: Raw waveform display

For the "Raw waveform display", a trace (selected by the "Amplitude trace #") will be displayed if this option is enabled. The top quarter of the display, or whatever is specified by the "Trace display height" parameter, will be used to display a sweep from this trace. Only the last sweep occurring in the analysis range will be displayed (horizontally), and a tick mark is shown below the sweep, lined up with the time (on the waveforms below) at which the frame containing the sweep was triggered. Deleted frames, and frames whose tag values are not in the "Tag list" are excluded. If the trace selected by the "Amplitude trace #" doesn't exist, the frame position is indicated, but no sweep is shown.

 

Key sequence  Parameter Initial Value
<Esc>SDWL  Last trace only  N

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.