Page: 312

Analysis Help
Parameter: Get cursor readings


Full name: Get cursor readings on displayed data
Parameter type: Y or N
Initial value: N

Affects: all analyses, visual parameter setting

If this option is enabled, the program will pause after every "sweep" of data is displayed, to allow you to get readings from the data.

You can set two markers, A and B, to two different points on the data, by using the pointing device to move the cursor to the desired position, then pressing either button A or B. The X and Y coordinates for the markers are displayed above the menu. You can also use space and backspace to move the last marker set forward or backward by one data point.

When you are finished with one sweep, press D to go on to the next one. You can also type a Q to quit entirely; this will simply disable this option.

 

Key sequence  Parameter Initial Value
<Esc>SDTC  Get cursor readings  N

 


SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.