| Page: 287 |
Affects: Raw waveform display
If this option is enabled, markers on the display will show where the cycles start, provided that the "Cycle W.F. #" parameter has been set, and the cycle related waveform parameters for that waveform have also been properly set. Similarly, if the "Display cycle lengths" option is enabled, the cycle lengths are indicated at the bottom of the display. If the "Display both crossings" option is enabled, in addition to the "Display crossings" option, then a second set of slightly smaller markers will also show the end of activity in each cycle.
| Key sequence | Parameter | Initial Value |
|---|---|---|
| <Esc>SWM | Display crossings | N |
SCRC WWW administrator:
www@scrc.umanitoba.ca
Copyright © 2011 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.