Page: 353

Analysis Help
Parameter: Calculate overlap

Home › Software › Analysis Help › Parameters › Calculate overlap


Full name: Calculate & show overlapping W.F. activity
Parameter type: Y or N
Initial value: N

Affects: Raw waveform display

This parameter tells the program whether to calculate the total amount of time in which the activity on each waveform overlaps with activity on the waveform selected by the "Cycle W.F. #". This amount is shown as a percentage of the total "on" time of these cycles, on the line above each waveform in the "Raw waveform display". The activity for each waveform is measured from the cycle activity bursts, if these have been set for this waveform, or the spike activity trains otherwise. If neither is set, the line will remain blank.

 

Key sequence  Parameter Initial Value
<Esc>SWO  Calculate overlap  N

 

SCRC WWW administrator: www@scrc.umanitoba.ca
Copyright © 2019 G. R. Detillieux, Spinal Cord Research Centre, The University of Manitoba.